Removal Procedure
- Remove the air cleaner. Refer to
Air Cleaner Replacement
.
- Unclip the wiring harness clip behind the A/C compressor and reposition the wiring harness.
- Remove the wiring harness clamp nut at the air intake pipe and reposition the wiring harness.
- Remove the nut, bolt, and the 2 wiring harness brackets and reposition the wiring harness.
- Disconnect the fuel rail pressure sensor electrical connector.
- Remove the bolt and wiring harness bracket from the turbocharger. Reposition the wiring harness.
- Reposition the positive crankcase ventilation (PCV) hose clamp at the resonator tee.
- Remove the PCV hose from the tee.
- Loosen the air intake pipe to turbocharger clamp (1).
- Remove the air intake pipe (2) from the turbocharger.
Installation Procedure
- Clean the mating surfaces on the air intake pipe and the turbocharger.
- Align the air intake pipe (2) to the turbocharger.
Notice: Refer to Fastener Notice in the Preface section.
- Tighten the air intake pipe to turbocharger clamp (1).
Tighten
Tighten the clamp to 4.6 N·m (41 lb in).
- Install the PCV hose to the tee.
- Position the PCV hose clamp at the resonator tee.
- Connect the fuel rail pressure sensor electrical connector.
- Reposition the engine harness to the original position.
- Clip the harness into the harness retainer.
- Install the engine harness clamp nut to the turbocharger.
Tighten
Tighten the nut to 10 N·m (89 lb in).
- Install the engine wiring harness clamps to the thermostat housing with nut and bolt.
Tighten
Tighten the nut and bolt to 25 N·m (18 lb ft).
- Install the air cleaner. Refer to
Air Cleaner Replacement
.