GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim.

  2. Object Number: 1334926  Size: SH
  3. Disconnect the turbocharger vane position sensor electrical connector.
  4. Remove the turbocharger vane position sensor connector from the bracket.
  5. Remove the turbocharger vane position sensor from the turbocharger.

Installation Procedure

    Notice: Refer to Component Fastener Tightening Notice in the Preface section.


    Object Number: 1334926  Size: SH
  1. Install the turbocharger vane position sensor to the turbocharger.
  2. Tighten
    Tighten the sensor to 23 N·m (17 lb ft).

  3. Install the turbocharger vane position sensor connector to the bracket.
  4. Connect the turbocharger vane position sensor electrical connector.
  5. Install the thermal reflective shield/tape, refer to the following procedure.

Thermal Reflective Shield/Tape Installation

Important: 

   • Ensure outside surface of sensor body is clean and oil-free prior to beginning the installation procedure. If sensor body surface is oily, use a mild degreaser in order to remove the oil from the surface. Ensure degreased surface is dry prior to beginning the installation.
   • The thermal reflective shield and tie strap are to be installed over the vane position sensor AFTER the sensor is installed and torqued in the turbo centerhousing. Graphics below show the sensor prior to the installation process for clarity purposes only.


    Object Number: 1488378  Size: SH
  1. Peel off the protective backing from the back side of the thermal reflective shield/tape.

  2. Object Number: 1488379  Size: SH
  3. With the sticky side of the shield/tape applied against the sensor body, align the bottom edge of the shield/tape with the bottom edge of the hex, and begin wrapping the sensor.

  4. Object Number: 1488381  Size: SH
  5. Completely wrap the shield/tape around the sensor.

  6. Object Number: 1488385  Size: SH
  7. Tuck the top of the shield/tape under the head of the brass cable crimp sleeve all around, allowing the shield/tape to fold over and overlap itself at the top.

  8. Object Number: 1488387  Size: SH
  9. The top of the shield/tape is now shown tucked under the head of the brass cable crimp sleeve all around.

  10. Object Number: 1488391  Size: SH
  11. Wrap the tie strap around the necked porting of the sensor body just above the hex. Insert the end of the strap in the buckle and tighten by pulling the end with needlenose pliers.

  12. Object Number: 1488393  Size: SH
  13. Bend the end of the tie strap 180 degrees over the top of the buckle.

  14. Object Number: 1488398  Size: SH
  15. Cut off the tie strap using side cutters so that the cut end will lie approximately over the center of the buckle. Push down the end of the tie strap over the buckle in order to minimize protrusion of the cut end or any sharp edges.

  16. Object Number: 1488400  Size: SH
  17. Finished installation is shown.
  18. Install the engine cover. Refer to Engine Cover Replacement in Engine Mechanical - 6.6L (LLY).
  19. Perform the turbocharger learn procedure. Refer to Turbocharger Learn .