GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2005 🢒 TopKick C-Series (Conventional) C4/C5 🢒 Vehicle Control Systems 🢒 Vehicle DTC Information 🢒 Vehicle Speed Sensor Replacement

Removal Procedure

    Object Number: 826892 Size: SH
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the vehicle speed sensor (VSS) electrical connector.

    3. Object Number: 690158 Size: SH
  3. Remove the VSS bolt, sensor and seal.

Installation Procedure

    Object Number: 690158 Size: SH
  1. Lubricate a NEW O-ring seal with transmission fluid.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the VSS and bolt.

    3. Tighten
    Tighten the VSS bolt to 10 N·m (89 lb in).


    Object Number: 826892 Size: SH
  3. Connect the VSS electrical connector .
  4. Lower the vehicle.
  5. Check the transmission fluid level. Add if necessary.