GM Service Manual Online
For 1990-2009 cars only

Diagnostic Aids

If the POWER WINDOWS fuse is open, the cause could be one of the following:

    • A short to ground in the accessory voltage circuit.
    • A short to ground in one of the power window signal or power window motor control circuits. This would open the POWER WINDOWS fuse with a switch activation.

Step

Action

Yes

No

Schematic Reference: Power Window Schematics

Connector End View Reference: Power Door Systems Connector End Views

DEFINITION: This diagnostic procedure should be used to diagnose a total failure of the power window system.

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

2

  1. Turn ON the ignition, with the engine OFF.
  2. Operate both power windows up and down from both the power window master switch and the individual power window switch.

Do both power windows operate up and down from both switches?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

3

Did either power window operate from either switch?

Go to Power Window Inoperative - Driver Door or Power Window Inoperative - Passenger Door

Go to Step 4

4

Check condition of the POWER WINDOWS circuit breaker.

Is the POWER WINDOWS circuit breaker open?

Go to Step 7

Go to Step 5

5

  1. Disconnect the power window master switch.
  2. Turn the ignition switch to the ON position.
  3. Connect a test lamp between the power window master switch accessory voltage circuit and ground.

Does the test lamp illuminate?

Go to Step 6

Go to Step 10

6

Connect the test lamp between the power window master switch ground circuit and battery positive voltage.

Does the test lamp illuminate?

Go to Step 9

Go to Step 11

7

Test for a short to ground in the accessory voltage circuit. Refer to Circuit Testing and Wiring Repairs.

Did you find and correct the condition?

Go to Step 13

Go to Step 8

8

Test for a short to ground in both the power window signal circuits and the power window motor control circuits. Refer to Circuit Testing and Wiring Repairs.

Did you find and correct the condition?

Go to Step 13

Go to Step 9

9

Inspect for poor connections at the left front power side window switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs.

Did you find and correct the condition?

Go to Step 13

Go to Step 12

10

Repair the open in power window master switch accessory voltage circuit. Refer to Circuit Testing and Wiring Repairs.

Did you complete the repair?

Go to Step 13

--

11

Repair the open in power window master switch ground circuit. Refer to Circuit Testing and Wiring Repairs.

Did you complete the repair?

Go to Step 13

--

12

Replace the power window master switch. Refer to Front Side Door Window Switch Replacement.

Did you complete the repair?

Go to Step 13

--

13

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3