Removal Procedure
- Drain the reservoir.
Important: Cap the hoses in order to prevent dirt from entering the system.
- Remove the hoses from the reservoir.
- Remove nuts holding the reservoir.
- Remove the reservoir.
Installation Procedure
- Install the reservoir to the vehicle.
Notice: Refer to Fastener Notice in the Preface section.
- Install the washers and the nuts.
Tighten
Tighten the reservoir mounting nuts to 28 N·m (21 lb ft).
- Connect the hoses to the reservoir.
- Bleed the system. Refer to
Power Steering System Bleeding
.