For 1990-2009 cars only
Removal Procedure
- Remove the drive belt. Refer to Drive Belt Replacement .
- Remove the drive belt idler pulley bolt at the power steering pump, if necessary.
- Remove the drive belt idler pulley from the power steering pump, if necessary.
- Remove the idler pulley shield.
- If equipped with air conditioning (A/C), remove the drive belt idler pulley bolt at the generator bracket, if necessary.
- Remove the drive belt idler pulley from the generator bracket, if necessary.
Installation Procedure
- Install the drive belt idler pulley to the generator bracket, if necessary.
- If equipped with A/C, install the drive belt idler pulley bolt at the generator bracket, if necessary.
- Install the idler pulley shield.
- Install the drive belt idler pulley to the power steering pump, if necessary.
- Install the drive belt idler pulley bolt at the power steering pump, if necessary.
- Install the drive belt. Refer to Drive Belt Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten drive belt idler pulley bolt to 50 N·m (37 lb ft).
Tighten
Tighten drive belt idler pulley bolt to 50 N·m (37 lb ft).
