Step | Action | Yes | No |
|---|---|---|---|
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Press each button of the transmitter one at a time. Does the system operate normally? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
3 | Lock and unlock the door locks using the controls inside the vehicle. Do the locks operate properly? | Go to Step 4 | |
4 |
Important: Inspect that the keyless entry transmitter is the correct model for the vehicle remote system. A wrong model transmitter may pass this test, but will not activate the vehicle remote system.
Does a tone sound and the green light illuminate on the J 43241 after each button is pressed? | Go to Step 9 | Go to Step 5 |
5 | Do any of the buttons on the transmitter sound the tone and illuminate the green light when pressed? | Go to Step 8 | Go to Step 6 |
6 | Replace the transmitter battery. Refer to Transmitter Battery Replacement . Did you complete the replacement? | Go to Step 7 | -- |
7 |
Does a tone sound and the green light illuminate on the J 43241 after each button is pressed? | Go to Step 9 | Go to Step 8 |
8 | Replace the transmitter. Did you complete the replacement? | Go to Step 10 | -- |
9 | Operate the transmitter within range of the vehicle. Do all of the keyless entry functions operate normally? | Go to Step 14 | Go to Step 10 |
10 |
Important: All transmitters which are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single programming sequence. If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Perform the programming procedure. Refer to Transmitter Programming . Did the locks cycle to lock then unlock? | Go to Step 14 | Go to Step 11 |
11 |
Did you find and correct the condition? | Go to Step 14 | Go to Step 12 |
12 | Test the ground circuit for opens. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 14 | Go to Step 13 |
13 | Test the class 2 circuit for an open or a short to ground. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 15 | Go to Step 14 |
14 | Replace the RCDLR. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 15 | -- |
15 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |
