Schematic Reference: Wiper/Washer Schematics

Connector End View Reference: Wiper/Washer Connector End Views

Did you review the Wiper/Washer System Description and Operation and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Wiper/Washer Systems

1. Turn the ignition ON.
2. Turn the windshield wiper/washer switch to the OFF position.

Are the windshield wipers always on?

Go to Step 3

Go to Testing for Intermittent Conditions and Poor Connections

1. Turn the ignition OFF.
2. Disconnect the steering column inline harness connector.
3. Remove the connector terminal row E from the steering column harness connector half.
4. Connect the steering column inline harness connector.
5. Turn the ignition ON.

Are the windshield wipers always on?

Go to Step 4

Go to Step 7

1. Disconnect the windshield wiper motor connector.
2. Test the windshield wiper switch pulse delay signal circuit for a short to voltage. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 9

Go to Step 5

Inspect for poor connections at the windshield wiper motor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 9

Go to Step 6

Replace the windshield wiper motor module. Refer to Windshield Wiper Motor Cover Replacement .

Is the repair complete?

Go to Step 9

--

Inspect for poor connections at the windshield wiper/washer switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 9

Go to Step 8

Replace the windshield wiper/washer switch. Refer to Turn Signal Multifunction Switch Replacement .

Is the repair complete?

Go to Step 9

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3