For 1990-2009 cars only
Disconnect Procedure
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
- Using compressed air, blow any dirt or debris from around the connection.
- This step applies to Bartholomew style connector ONLY. Squeeze the plastic quick connect fitting release tabs.
- This step applies to Release Tab style connector ONLY. Release the fitting by pushing the tab toward the other side of the slot in the fitting.
- This step applies to the Squeeze to Release style connector ONLY. Squeeze where indicated by the arrows shown above on both sides of the plastic ring surrounding the quick connect fitting.
- This step applies to the Sliding Retainer style connector ONLY. Release the fitting by pressing on one side of the release tab causing it to push in slightly. If the tab does not move try pressing the tab in from the opposite side. The tab will only move in one direction.
- This step applies to the Push Down TI style connector ONLY. Release the fitting by pressing on the tab indicated by the arrow.
- Pull the connection apart.
Important: There are several types of Plastic Collar Fuel and Evaporative Emission Quick Connect Fittings used on this vehicle.
• Bartholomew (1) • Q Release (2) • Squeeze to Release (3) • Sliding Retainer (4)
The following instructions apply to all of these types of Plastic Collar Quick Connect Fittings except where indicated.
• Push Down TI (5)
Caution: Refer to Safety Glasses Caution in the Preface section.
Connect Procedure
- Apply a few drops of clean engine oil to the male connection end.
- Push both sides of the quick-connect fitting together in order to cause the retaining feature to snap into place.
- Once installed, pull on both sides of the connection in order to make sure the connection is secure.
- Install the fuel fill cap.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
Caution: Refer to Fuel Pipe Fitting Caution in the Preface section.
