Removal Procedure
- Disconnect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
.
- Disconnect the vehicle's engine wiring harness electrical connector (1) from the glow plug control module.
- Disconnect the engine wiring harness electrical connector (2) from the glow plug control module.
- Remove the glow plug control module bolts (1).
- Remove the glow plug control module.
- Remove the glow plug control module bracket bolts (2), if required.
- Remove the glow plug control module bracket, if required.
Installation Procedure
- Position the glow plug control module bracket to the fuel pipe bracket, if required.
Notice: Refer to Fastener Notice in the Preface section.
- Install the glow plug control module bracket bolts (2), if required.
Tighten
Tighten the bolts to 10 N·m (89 lb in).
- Position the glow plug control module to the bracket.
- Install the glow plug control module bolts (1).
Tighten
Tighten the bolts to 10 N·m (89 lb in).
- Connect the engine wiring harness electrical connector (2) to the glow plug control
module.
- Connect the vehicle's engine wiring harness electrical connector (1) from the glow plug control module.
- Connect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
.
- If a NEW glow plug control module was installed, program the module. Refer to
Control Module References
.