Fuel Pump Replacement NG6

1. Loosen the fuel fill cap in order to relieve the fuel system pressure.
2. Raise and suitably support the vehicle, if required. Refer to Lifting and Jacking the Vehicle.
3. Disconnect the wiring harness electrical connector from the fuel pump electrical connector.
4. Clean the fuel pipe connections and surrounding areas at the pump before disconnecting in order to avoid possible fuel system contamination.
5. Disconnect the fuel pipes from the fuel pump.



6. Slide the fuel pump out from the bracket.
7. Cap the ends of the fuel pipes.

1. Remove the caps from the ends of the fuel pipes.
2. Install NEW fuel pipe O-rings into the fuel pipe fittings.
3. Slide the fuel pump into the bracket.

Caution: Refer to Fastener Caution in the Preface section.




4. Connect the fuel pipes to the fuel pump.

Tighten
Tighten the fittings to 30 N·m (22 lb ft).

5. Connect the wiring harness electrical connector to the fuel pump electrical connector.
6. Lower the vehicle, if required.
7. Install the fuel fill cap.
8. Start the engine and inspect for leaks.