Special Tools

J 37228 Seal Cutter

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Place a suitable container under the engine in order to drain the oil.
3. Remove the oil drain plug.
4. Drain the engine oil.



5. Disconnect the oil level sensor electrical connector.



6. Remove the lower oil pan bolts/nuts.

Note: DO NOT damage the sealing surfaces when separating the lower oil pan from the upper oil pan.

7. Separate the lower oil pan from the upper oil pan using J 37228 .
8. Remove the lower oil pan.
9. If necessary, clean and inspect the lower oil pan. Refer to Lower Oil Pan Cleaning and Inspection.

1. Apply a 2-3 mm (0.79-0.118 in) by 0.5-1.5 mm (0.02-0.06 in ) wide bead of sealant to the lower oil pan mating surface. Refer to Adhesives, Fluids, Lubricants, and Sealers for the correct part number.



2. Install the lower oil pan.
3. Install the lower oil pan bolts/nuts.

Caution: Refer to Fastener Caution in the Preface section.




4. Tighten the oil pan bolts/nuts in the sequence shown.

Tighten
Tighten the bolts/nuts to 10 N·m (89 lb in).




5. Connect the oil level sensor electrical connector.
6. Install NEW engine oil and a oil filter. Refer to Engine Oil and Oil Filter Replacement.
7. Lower the vehicle.