Removal Procedure
- Remove the fuel tank. Refer to
Fuel Tank Replacement
.
- Disconnect the fuel feed and return pipe fittings at the fuel filter inlet and the return pipe union.
- Remove the fuel feed and return pipes from the retaining clips.
Installation Procedure
- Install the fuel feed and return pipes into the retaining clips.
- Install the fuel tank. Refer to
Fuel Tank Replacement
.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Connect the fuel feed and return pipes to the fuel filter inlet and the return pipe union.
Tighten
Tighten the fuel pipe fittings to 27 N·m (20 lb ft) using a back-up wrench.
- Lower the vehicle.
- Refill the fuel system.
- Tighten the fuel filler cap.
- Connect the negative battery cable.
- Inspect for fuel leaks.
| 8.1. | Turn ON the ignition for 2 seconds. |
| 8.2. | Turn OFF the ignition for 10 seconds. |
| 8.3. | Turn ON the ignition. |
| 8.4. | Inspect for fuel leaks. |
