The following service procedures require either a programming or a setup event performed for a complete repair.
If the glow plug controller (GPCM) is replaced, the following procedures must be performed.
• | Fuel Injector Flow Rate Programming for fuel injector flow rate programming |
• | Service Programming System (SPS) for GPCM programming |
If the glow plug controller (GPCM) needs to be reprogrammed, refer to Service Programming System (SPS) .
The replacement of some components will require a setup procedure for complete repair.
If any of the following components are replaced, the Fuel Injector Flow Rate Programming must be performed.
• | Fuel injector |
• | Engine control module (ECM) |
• | GPCM |
This module does not require that a programming event or a setup event is performed.