Removal Procedure
- Disconnect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection .
- Disconnect the 2 engine harness electrical connectors from the glow plug
control module.
- Remove the glow plug control module bolts.
- Remove the glow plug control module.
- Remove the glow plug control module bracket bolts, if required.
- Remove the glow plug control module bracket, if required.
Installation Procedure
- Install the glow plug control module bracket, if required.
Notice: Refer to Fastener Notice in the Preface section.
- Install the glow plug control module bracket bolts, if required.
Tighten
Tighten the bolts to 10 N·m (89 lb in).
- Install the glow plug control module.
- Install the glow plug control module bolts.
Tighten
Tighten the bolts to 10 N·m (89 lb in).
- Connect the 2 engine harness electrical connectors
to the glow plug control module.
- Connect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection.
- If a NEW glow plug control module was installed, program the module. Refer
to
Control Module References .