Glow Plug Control Module Programming and Setup RPO LLY or LBZ

The following service procedures require either a programming or a setup event performed for a complete repair.

If the glow plug controller (GPCM) is replaced, the following procedures must be performed.

If the glow plug controller (GPCM) needs to be reprogrammed, refer to Service Programming System (SPS) .

The replacement of some components will require a setup procedure for complete repair.

If any of the following components are replaced, the Fuel Injector Flow Rate Programming must be performed.

Glow Plug Control Module Programming and Setup RPO LG4

This module does not require that a programming event or a setup event is performed.