GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 9886-01 Door Handle Clip Remover

Removal Procedure


    Object Number: 5087  Size: SH
  1. Use J 9886-01 in order to remove the window regulator handle, if equipped.
  2. Remove the front door garnish. Refer to Front Side Door Front Garnish Molding Replacement .
  3. Remove the front door trim plate. Refer to Front Door Trim Plate Replacement .
  4. Remove the screws from the arm rest. Refer to Pull Handle Replacement .

  5. Object Number: 333940  Size: SH
  6. Lift up on the front door trim panel (1) in order to release the retaining tabs on the front door trim panel.
  7. Remove the front door trim panel (1) from the vehicle.

Installation Procedure


    Object Number: 333940  Size: SH
  1. Install the front door trim panel (1) to the vehicle.
  2. Align the retaining tabs on the front door trim panel with the holes in the door.
  3. Push down on the retaining tabs in order to lock the retaining tabs into place.
  4. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 333938  Size: SH
  5. Install the screws to the arm rest.
  6. Tighten
    Tighten the arm rest retaining screws to 1.9 N·m (17 lb in).

  7. Install the front door front garnish. Refer to Front Side Door Front Garnish Molding Replacement .
  8. Install the front door trim plate. Refer to Front Door Trim Plate Replacement .
  9. Install the window regulator handle (1), if equipped.