The EBCM is able to self-configure to multiple ABS systems.
The self-configuration process must be initiated when a new EBCM is installed
in a vehicle. All system components must be properly connected
and functional in order to successfully configure the EBCM. Use
the procedure described below in order to configure the EBCM to
the specific vehicle.
- Turn the ignition ON.
- If the vehicle is equipped with traction control (TC), press and
release the TC switch.
- Hold the magnet against the switch on the EBCM labeled RESET.
- Continue to hold the magnet against the reset switch for approximately
20 seconds.
- Remove the magnet from the RESET switch when the LEDs begin to
flash.
- The non-TC configuration process is complete when the EBCM displays
illuminated FRT, RER, and SEN LEDs. Vehicles configured with TC illuminates
FRT, RER,SEN and then TRC,MOD.