- Install the air shift harness to the vehicle.
- If equipped with the 10 speed transmission, connect the following tubes:
| • | Green tube (1) to the "H" port to "L" port |
| • | Black tube (2) to the "P" port |
| • | Blue tube (3) to the "SP" port |
| • | Red tube (4) to the "S" port |
- If equipped with the 9 speed transmission, connect the following tubes:
| • | Red tube (1) to the "S" port |
| • | Black tube (2) to the "P" port |
- Lower the vehicle.
Notice: Refer to Fastener Notice in the Preface section.
- Install the transmission boot and bolts.
Tighten
Tighten the transmission boot bolts to 2 N·m (18 lb in).
- Install the boot retainer plate and bolts, if equipped.
Tighten
Tighten the boot retainer plate bolts to 2 N·m (18 lb in).
- Install the control lever retainer and bolts.
Tighten
Tighten the control lever retainer bolts to 2 N·m (18 lb in).
- Install the shift lever sheath.
- Perform the following steps in order to install the air shift control lever:
| 9.1. | Screw the shift control lever on completely, then back off until the lever or selector button points to the driver side of the cab. |
| 9.2. | Tighten the lock nut against the shift control lever. |
Tighten
Tighten the shift lever lock nut to 25 N·m (18 lb ft).
- If equipped with the 10 speed transmission, connect the following tubes:
| • | Blue tube (1) to the "SP" port |
| • | Black tube (2) to the "P" port |
| • | Red tube (3) to the "S" port |
| • | Green tube (4) to the "H" port to "L" port |
- If equipped with the 9 speed transmission, connect the following tubes:
| • | Red tube (1) to the "S" port |
| • | Black tube (2) to the "P" port |
- Slide the sheath up the shift lever.
- Install the screws to the transmission shift sheath.
Tighten
Tighten the control lever sheath screws to 5 N·m (44 lb in).
- Pressurize the system.
- Operate the shift control valve to check for leaks.
