For 1990-2009 cars only
Removal Procedure
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General information.
- Place a suitable drain pan under the transmission in order to catch the drained transmission fluid.
- Remove the drain plug and drain the transmission fluid. Ensure all of the fluid is drained.
Installation Procedure
- Remove the oil fill plug
- Install the transmission drain plug and O-ring seal. Ensure the O-ring seal is not damaged.
- Fill the transmission to just below the bottom of the fill plug hole. Refer to Lubrication Specifications .
- Install the oil fill plug.
- Lower the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the oil drain plug to 35 N·m (26 lb ft).
Tighten
Tighten the oil drain plug to 35 N·m (26 lb ft).
