For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B0790: Transfer Case Neutral Indicator Circuit MalfunctionCircuit/System Description
The Neutral indicator circuit consists of an ignition 3 voltage circuit and a Neutral indicator control circuit. When the Neutral mode has been selected by the driver, current is supplied to the Neutral indicator by the ignition 3 voltage circuit, traveling through the Neutral indicator LED at which time the transfer case shift control module supplies the ground through the Neutral indicator control circuit. This DTC detects an open, short to ground or a short to voltage.
Conditions for Running the DTC
| • | The ignition is ON. |
| • | The system voltage is 9-18 volts. |
Conditions for Setting the DTC
| • | The system monitors the voltage on the Neutral indicator control circuit. |
| • | If the system detects a voltage of 3 volts or less for 1.5 seconds when the Neutral indicator is not commanded, the DTC is logged. |
| • | If the system detects a voltage of 4.5 volts or more when the Neutral indicator is commanded, the DTC is logged. |
Action Taken When the DTC Sets
The SERVICE 4WD indicator is not illuminated.
Conditions for Clearing the DTC
| • | The transfer case shift control module will clear the DTC if the condition for setting the DTC is not currently present. |
| • | A history DTC will clear after 100 consecutive ignition cycles without a fault present. |
| • | History DTCs can be cleared using a scan tool. |
Reference Information
Schematic Reference
Transfer Case Control Schematics
Connector End View Reference
Description and Operation
Transfer Case Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
