Diagnostic Instructions
DTC Descriptor
DTC C0327: Encoder Circuit Malfunction
Circuit/System Description
The transfer case encoder is an analog sensor that returns a signal that represents the physical position of the transfer case sector shaft. This signal represents the mode or range position that the transfer case is currently in. This sensor is made up
of the following 3 circuits:
| • | 5-volt reference circuit |
| • | Encoder low reference circuit |
This DTC detects an out of range reading from the encoder signal, a short to voltage on the 5-volt reference circuit.
Conditions for Setting the DTC
The transfer case shift control module has a predefined range, 0.5-4.5 volts, in which the encoder feed back should stay within. The DTC sets if the encoder signal feed back falls out of this range.
Action Taken When the DTC Sets
| • | All motor activity stops. |
| • | The SERVICE 4WD indicator is not illuminated. |
Conditions for Clearing the DTC
| • | The transfer case shift control module will clear the DTC if the condition for setting the DTC is not currently present. |
| • | A history DTC will clear after 100 consecutive ignition cycles without a fault present. |
| • | History DTCs can be cleared using a scan tool. |
Diagnostic Aid
Check the mechanical condition of the shift lever detent shaft connected to the motor. If this shaft has too much mechanical play this can cause an under voltage or over voltage from the encoder causing the DTC to set.
Reference Information
Schematic Reference
Transfer Case Control Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Transfer Case Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References
for scan tool information.
Repair Instructions
Perform the
Diagnostic Repair Verification
after completing the diagnostic procedure.
