Warning: Refer to Brake Fluid Irritant Warning in the Preface section.

Caution: Refer to Brake Fluid Effects on Paint and Electrical Components Caution in the Preface section.

1. Clean the caps and connection to keep contamination out of reservoir.
2. Remove the brake fluid from the master cylinder reservoir.
3. Remove the connector.



4. Remove the fluid level switch from the reservoir. Use a pick or a thin tool in order to reach into the slot on the bottom of the reservoir. Compress the tabs while pulling out on the sensor.

1. Install the fluid level switch into the reservoir until the tabs click.



2. Install the connector.
3. Fill the master cylinder with brake fluid. Refer to Master Cylinder Reservoir Filling.
4. Bleed the brake system. Refer to Hydraulic Brake System Bleeding.