The scan tool used provides the following capabilities:

Verify that the scan tool contains the latest diagnostic information before attempting to communicate with the SIR system. In order to use the scan tool, connect the scan tool to the data link connector (DLC) and turn the ignition switch to the RUN position. The scan tool reads the serial data sent from the inflatable restraint sensing and diagnostic module (SDM) serial data output terminal 5 to the DLC terminal 9.

The SIR Scan Tool Data List contains all restraint related parameters that are available on the scan tool. The list is arranged in the order as they appear on the scan tool.

Use the SIR Scan Tool Data List only after the following items are determined:

Scan tool values from a properly operating system may be used for comparison with the SIR system you are diagnosing. The SIR Scan Tool Data List represents the typical values seen on a properly operating system.

Important: Verify that the scan tool that you are using is functioning properly. Use of a malfunctioning scan tool can result in misdiagnosis and unnecessary parts replacement.

Only the parameters listed below are referenced in this service manual for use in diagnosis. If all values are within the typical range described below, refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.