For 1990-2009 cars only
Removal Procedure
- Open the hood
- The C clip was not design for removal. Damage may occur.
- Cable adjustment will be needed for proper operation.
- Disconnect the cruise control cable from the throttle lever.
- Disconnect the cruise control cable from the throttle linkage.
- Disconnect the cruise control cable from the cable bracket.
- Disconnect the cruise control cable from the cruise control module housing.
- Disconnect the cable bead (2) from the buckle on the end of the ribbon (1).
- Remove the cruise control cable from the vehicle.
Important: Do not remove the C clip from the cruise control end connector.
Important: Do not remove the adjuster screw from the end of the cruise control cable.
Using a suitable tool to lightly pry off the end of the cruise control cable.
Important: Do not allow the cruise control ribbon to retract into the module assembly.
Installation Procedure
- Route the cruise control cable (1) from the cruise control module to the throttle lever.
- Remove all bends and twists from the cruise control module ribbon and cable, by rotating until removed.
- Pull the cruise control cable (1), engine end fitting until the cable is taut.
- Install the cable bead (2) to the buckle on the end of the ribbon (1) on the cruise control module.
- Check the orientation of the cruise control ribbon buckle to the cable end fitting.
- Snap the cruise control cable fitting (3) into the cruise control module (4).
- Install the cruise control cable fitting into the round hole in the accelerator bracket.
- Connect the cruise control cable connector (2) to the throttle linkage (1).
- Adjust the cruise control cable. Refer to Cruise Control Cable Adjustment .
- Close the hood.
Important: Do not twist the cruise control module ribbon.
Important: Verify that the cable fitting locking tabs are expanded, and that the tabs are locked in the accelerator bracket hole.
