GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2000 🢒 Yukon Denali 🢒 Body and Accessories 🢒 Exterior Trim 🢒 Front Fender Wheel Opening Molding Replacement

Front Fender Wheel Opening Molding Replacement Pickup,Utility (Left)

Removal Procedure

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  1. Remove the battery if equipped with auxiliary battery. Refer to Battery Replacement in Engine Electrical.
  2. Remove the left fender. Refer to Front Fender Replacement in Body Front End.

    3. Object Number: 311550 Size: SH
  3. Remove the speed nuts (2) and clips from the molding.
  4. Remove the molding (4) from the fender.

Installation Procedure

    Object Number: 311550 Size: SH
  1. Install the molding (4) to the fender.
  2. Install the speed nuts (2) and clips to the molding.
  3. Install the left fender. Refer to Front Fender Replacement in Body Front End.
  4. Install the battery negative cable.

Front Fender Wheel Opening Molding Replacement Pickup, Utility (Right)

Removal Procedure

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  1. Remove the battery. Refer to Battery Replacement in Engine Electrical.
  2. Remove the right fender from the vehicle. Refer to Front Fender Replacement in Body Front End.

    3. Object Number: 519713 Size: SH
  3. Remove the speed nuts (2) and clips from the molding.
  4. Remove the molding (4) from the fender.

Installation Procedure

    Object Number: 519713 Size: SH
  1. Install the molding (4) to the fender.
  2. Install the speed nuts (2) and clips to the molding.
  3. Install the right fender. Refer to Front Fender Replacement in Body Front End.
  4. Install the battery. Refer to Battery Replacement in Engine Electrical.