Door Latch Replacement Cargo Door Lower

1. Remove the bolts that retain the latch assembly to the door.
2. Disconnect electrical connector, if required.



3. Remove the actuator cable assembly from the latch.

1. Install the actuator cable assembly to the latch.
2. Connect electrical connector, if required.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the bolts that retain the latch assembly to the door.

Tighten
Tighten the bolts to 25 N·m (18 lb ft).

Door Latch Replacement Cargo Door Upper

1. Remove the door trim panel. Refer to Rear Door Trim Panel Replacement .
2. Remove the bolts that retain the latch to the door.
3. Remove latch from the door.



4. Remove the actuator cable assembly from the latch.
5. Remove the latch bolts.
6. Remove the latch from the door.

1. Install the actuator cable assembly to the latch.
2. Install the latch assembly.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Loose assemble the bottom 2 bolts.

3.1.	Close door to self adjust latch assembly.

Tighten
Tighten bolts to 9 N·m (80 lb in).

3.2.	Open the door.

3.3.	Install the upper bolt.

Tighten
Tighten the bolt to 9 N·m (80 lb in).

4. Install the door trim panel. Refer to Rear Door Trim Panel Replacement .