Heated and Cooled Seat Switch Replacement Front-Platinum Models

1. Remove the floor console bezel. Refer to Floor Console Bezel Replacement .



2. Remove the 4 retaining screws (1).
3. Remove the switch assembly from the console bezel.

1. Install the switch assembly to the bezel.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the 4 retaining screws (1).

Tighten
Tighten the screws to 2 N·m (18 lb in).

3. Install the floor console bezel. Refer to Floor Console Bezel Replacement .

Heated and Cooled Seat Switch Replacement Rear-Platinum Models

1. Insert a flat bladed tool on either side of the switch in order to pry outwards.
2. Pull the switch out to gain access to the wire connector.
3. Disconnect the wire connector.

1. Connect the wire connector to the switch.
2. Install the switch into the opening until it clicks in places.