DTC C0269 or C0274 and C069 or C074. GMC Truck Yukon Denali 2005

For 1990-2009 cars only

Makes 🢒 GMC_Truck 🢒 2005 🢒 Yukon Denali 🢒 Accessories 🢒 Navigation Systems 🢒 DTC C0269 or C0274 and C069 or C074

Circuit Description

The system relay is energized when the ignition is ON. The system relay supplies voltage to the valve solenoids and the pump motor. This voltage is referred to as the system voltage. The electronic brake control module (EBCM) microprocessor activates the valve solenoids by grounding the control circuit.

DTC Descriptors

This diagnostic procedure supports the following DTCs:

•	DTC C0269 Excessive Dump Time

•	DTC C0274 Excessive Isolation Time

Conditions for Running the DTC

•	The ignition is ON.

•	The vehicle is experiencing an ABS event.

Conditions for Setting the DTC

C0269

The EBCM commands a dump solenoid ON for 9 consecutive seconds.

C0274

The EBCM commands an isolation solenoid ON for 255 consecutive seconds.

Action Taken When the DTC Sets

If equipped, the following actions may occur:

•	The EBCM disables the ABS/TCS/DRP.

•	The ABS indicator turns ON.

•	The TRACTION OFF indicator turns ON.

•	The red brake warning indicator turns ON.

Conditions for Clearing the DTC

The conditions for setting the DTC are no longer present and you use the scan tool Clear DTCs function.

Diagnostic Aids

The most likely cause of DTC C0269 or DTC C0274 is a mechanical failure that causes a wheel to lock and remain locked. The DTCs may also set, conceivably, when the ABS is activated on surfaces that are nearly impossible to get traction on. If the DTC sets within these conditions, diagnosis of the ABS system is not necessary.

Test Description

The number below refers to the step number on the diagnostic table:

Performing solenoid tests determines if there is a mechanical malfunction inside the BPMV. Perform dump valve solenoid tests for DTC C0269 or isolation valve solenoid tests for DTC C0274.

Step	Action	Yes	No
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Use a scan tool in order to clear the DTCs. Use the scan tool in order to perform the necessary Solenoid Tests. Refer to Scan Tool Output Controls . Do the Solenoid Tests show the system to be functioning normally?	Go to Diagnostic Aids	Go to Step 3
3	Replace the BPMV. Refer to Brake Pressure Modulator Valve Replacement . Did you complete the replacement?	Go to Step 4	--
4	Use the scan tool in order to perform the necessary Solenoid Tests. Do the Solenoid Tests show the system to be functioning normally?	System OK	Go to Step 3