Removal Procedure
Caution: Refer to SIR Inflator Module Handling and Storage Caution in the Preface section.
Caution: When carrying an undeployed inflatable restraint seat belt pretensioner:
• | Do not carry the seat belt pretensioner by the wires or connector. |
• | Carry the seat belt pretensioner by the piston tube, keeping hands and
fingers away from the cable. |
• | Make sure the open end of the seat belt pretensioner piston tube points
away from you and other people. |
• | Do not cover the seat belt pretensioner piston tube opening with your
hand. |
Failure to observe these guidelines may result in personal injury.
- Disable the SIR system. Refer to
SIR Disabling and Enabling
or
SIR Disabling and Enabling
.
- Remove the front door trim panel. Refer to
Front Side Door Trim Panel Replacement
in Doors.
- Loosen the 2 inflatable restraint side impact sensor fasteners (2).
- Remove the inflatable restraint side impact sensor (1) from the door (4).
- Remove the connector position assurance (CPA) (3), and disconnect the inflatable restraint side impact sensor yellow 2-way harness connector (5).
Installation Procedure
- Connect the inflatable restraint side impact sensor yellow 2-way harness connector (5) to the inflatable restraint side impact sensor (1).
- Install the CPA (3) to the inflatable restraint side impact sensor yellow 2-way connector (5).
- Install the inflatable restraint side impact sensor (1) to the door (4).
Notice: Refer to Fastener Notice in the Preface section.
- Install the fasteners (2) to the inflatable restraint side impact sensor (1) using only hand tools.
Tighten
Tighten the fasteners to 10 N·m (89 lb in).
- Install the door trim panel. Refer to
Front Side Door Trim Panel Replacement
in Doors.
- Enable the SIR system. Refer to
SIR Disabling and Enabling
or to
SIR Disabling and Enabling
.