Removal Procedure
Notice: Handle the electronic throttle control components carefully. Use cleanliness
in order to prevent damage. Do not drop the electronic throttle control components.
Do not roughly handle the electronic throttle control components. Do
not immerse the electronic throttle control components in cleaning solvents
of any type.
- Remove the knee bolster. Refer to
Knee Bolster Replacement .
- Push down the small tab and disconnect the accelerator pedal position (APP) sensor electrical connector (1).
- Remove the accelerator pedal bolts.
- Remove the accelerator pedal.
Installation Procedure
- Position the accelerator pedal to the accelerator pedal bracket.
Notice: Refer to Fastener Notice in the Preface section.
- Install the accelerator pedal bolts.
Tighten
Tighten the bolts to 9 N·m (80 lb in).
- Connect the APP sensor electrical connector (1).
- Connect a scan tool to the diagnostic port in order to test for proper throttle-opening and throttle-closing range.
- Operate the accelerator pedal and monitor the throttle angles. The accelerator pedal should operate freely, without binding, between a closed throttle, and a wide open throttle (WOT).
- Verify that the vehicle meets the following conditions:
• | The vehicle is not in a reduced engine power mode. |
- Install the knee bolster. Refer to
Knee Bolster Replacement .