• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
---|---|---|---|---|
I/P Dimming Voltage Reference | B1395 03 and B3600 03 | B1395 03, B2652 00, and B3600 03 | B1395 07 | B1395 03, B1395 07 |
Stop Lamp Signal | B1395 03 and B3600 03 | -- | -- | -- |
Voltage for the interior backlighting components and stop lamp switch activation signal is supplied from the body control module (BCM). The BCM applies a voltage reference through the instrument panel (I/P) dimming voltage reference circuit to the interior lamp dimming switch, which is part of the headlamp switch. When the dimming switch is placed in the desired position, the dimmed voltage setting is applied from the interior lamp dimming switch through the I/P dimming control circuit to the BCM. The BCM then applies the dimmed voltage to the I/P lamps supply voltage circuit and they dim to the correct level.
The stop lamp switch is also supplied voltage on the same circuit for a stop lamp OFF signal to the BCM. When the stop lamp switch is activated the voltage signal circuit to the BCM is opened prompting the BCM to illuminate the stop lamps.
The ignition is ON.
The BCM detects a voltage that is lower than 0.33 volt on the I/P dimming voltage reference circuit.
The BCM detects a voltage that is greater than 4.97 volts on I/P dimming voltage reference circuit.
The BCM detects a voltage that is lower than 0.10 volt on the I/P dimming control circuit.
• | The I/P lamps are dim or not illuminated. |
• | The I/P lamps will not dim. |
• | The stop lamps are always ON. |
• | The conditions for setting the DTC are no longer present. |
• | A history DTC clears after 100 malfunction-free ignition cycles. |
• | The BCM receives the clear code command from the scan tool. |
Lighting Systems Connector End Views
Ignition ON, cover the ambient light sensor. Vary the interior lamp dimming switch from dim to full bright. The I/P lamps should dim and then become full bright.
⇒ | If less than 0.33 volt, test the I/P dimming voltage reference circuit for a short to ground or an open/high resistance and test the stop lamp signal circuit for a short to ground. If the circuit/connections test normal, replace the BCM. |
⇒ | If greater than 4.97 volts, test the I/P dimming voltage reference circuit for a short to voltage. If the circuit/connections test normal, replace the BCM. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
• | Control Module References for BCM replacement, setup, and programming |