Tools Required
- Assemble the
J 25025-B
by attaching the threaded rod and the dial indicator
holder to one of the bolt holes on the transmission case assembly (7).
- Assemble the
J 8001-3
onto the dial indicator holder. Index the
J 8001-3
to the end of the turbine shaft (502).
- Eliminate any slack by pressing down on the turbine shaft (502).
- Using the
J 28585
, apply upward pressure on the output carrier assembly to remove free play in the retainer ring.
- Set the
J 8001-3
to 0.
- Pull up on the turbine shaft (502) while holding up the output carrier assembly with the
J 28585
. The correct end play is between 0.102-0.559 mm (0.004-0.022 in).
Important: During reassembly, the front end play check must be repeated in order to verify the accuracy of the selective washer.
- Record this measurement for future reference.
- Remove the tools.