Note: Clean all evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting, in order to avoid possible EVAP system contamination.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Disconnect the fuel tank EVAP line quick connect fitting (3) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service.
3. Disconnect the fuel tank EVAP line quick connect fitting (2) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service.
4. Disconnect the EVAP pipe quick connecting fitting (1) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service.



5. Remove the EVAP canister bracket bolts (1).
6. Remove the EVAP canister assembly (2) from the tab on the frame bracket.



7. Remove the EVAP canister bolt (1).
8. Remove the EVAP canister (2) from the bracket (3).

1. Install the EVAP canister (2) to the bracket (3).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the EVAP canister bolt (1).

Tighten
Tighten the bolt to 25 N·m (18 lb ft).




3. Position and install the EVAP canister assembly (2) to the fame bracket tab.
4. Install the EVAP canister bolts (1).

Tighten
Tighten the bolts to 25 N·m (18 lb ft).




5. Connect the EVAP pipe quick connecting fitting (1) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service.
6. Connect the fuel tank EVAP line quick connect fitting (2) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service.
7. Connect the fuel tank EVAP line quick connect fitting (3) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service.
8. Lower the vehicle.