The PG starter motors are non-repairable. They have pole pieces that are arranged around the armature. Both solenoid windings are energized. The pull-in winding circuit is completed to the ground through the starter motor. The windings work together magnetically to pull and hold in the plunger. The plunger moves the shift lever. This action causes the starter drive assembly to rotate on the armature shaft spline as it engages with the flywheel ring gear on the engine. Moving at the same time, the plunger also closes the solenoid switch contacts in the starter solenoid. Full battery voltage is applied directly to the starter motor and it cranks the engine.

Description and Operation

Starting System Description and Operation

Start the engine. Listen to the starter noise while the engine is cranking. Compare the concern to a similar vehicle.

1. Remove the flywheel inspection cover.
2. Inspect the flywheel for the following:

•	Loose flywheel bolts

•	Chipped gear teeth

•	Missing gear teeth

•	Bent flywheel

•	Debris in the bell housing

⇒	If not within specifications, remove the debris, tighten the flywheel bolts, or repair or replace the flywheel.

3. If all inspections were within specification, replace the starter motor.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.