Removal Procedure
- Remove the automatic transmission. Refer to
Transmission Replacement
for
the 4L60-E transmission or
Transmission Replacement
for the 4L80-E transmission.
Important: Note the position and direction of the engine flywheel before removal.
- Remove the flywheel bolts.
- Remove the flywheel.
- Install 2 M11x1.5 mm bolts (1) to the threaded holes of the spacer, if applicable.
- Rotate the bolts clockwise to remove the spacer.
- Remove the spacer from the rear of the crankshaft, if applicable.
Installation Procedure
Important:
• | The flywheel does not use a locating pin for alignment and will not initially seat against the crankshaft flange or spacer, if applicable, but will be pulled onto the crankshaft by the engine flywheel bolts. This procedure requires a three stage
tightening process. |
• | Certain applications (6.0L) require a spacer and longer bolts for proper flywheel position. |
- Install the spacer, if applicable, onto the rear of the crankshaft.
- Install the flywheel and bolts to the crankshaft.
Important: Longer flywheel bolts must be used on applications using a flywheel spacer.
- Apply threadlock to the threads of the flywheel bolts. Refer to
Adhesives, Fluids, Lubricants, and Sealers
for the correct part number.
Notice: Refer to Fastener Notice in the Preface section.
- Tighten the flywheel bolts.
Tighten
- Tighten the bolts a first pass in sequence to 20 N·m (15 lb ft).
- Tighten the bolts a second pass in sequence to 50 N·m (37 lb ft).
- Tighten the bolts a final pass in sequence to 100 N·m (74 lb ft).
- Install the automatic transmission. Refer to
Transmission Replacement
for the 4L60-E transmission or
Transmission Replacement
for the 4L80-E transmission.