Tools Required
J 41479
Crankshaft Rear Oil Seal Installer
Important:
• | Do not lubricate the oil seal inside diameter (ID) or the crankshaft surface. |
• | Do not use the crankshaft rear oil seal again. |
- Lubricate the outside diameter (OD) of the oil seal (141) with clean engine oil.
DO NOT allow oil or other lubricants to contact the seal surface.
- Lubricate the rear housing oil seal bore with clean engine oil.
DO NOT allow oil or other lubricants to contact the crankshaft surface.
- Install the
J 41479
cone (2)
and bolts onto the rear of the crankshaft.
- Tighten the bolts until snug. Do not overtighten.
- Install the rear oil seal onto the tapered cone (2) and push the seal to the rear housing bore.
- Thread the
J 41479
threaded rod into the tapered cone until the tool (1) contacts the oil seal.
- Align the oil seal onto the tool (1).
- Rotate the handle of the tool (1) clockwise until the seal enters the rear housing and bottoms into the housing bore.
- Remove the tool.