Endgate Handle Replacement Avalanche

1. Remove the endgate handle bezel. Refer to Endgate Adjustment .
2. Release the endgate handle linkage rod retainers. Refer to Endgate Adjustment .



3. Remove the 3 bolts (1) that retain the handle to the endgate.
4. Remove the endgate spoiler. Refer to Rear Spoiler Replacement .
5. Remove the handle.

1. Set the handle in position in the endgate.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the 3 bolts (1) that retain the handle to the endgate.

Tighten
Tighten the bolts to 25 N·m(18 lb ft).

3. Install the endgate spoiler. Refer to Rear Spoiler Replacement .
4. Reattach the handle linkage rods and adjust the endgate latch. Refer to Endgate Adjustment .
5. Reattach the endgate handle bezel. Refer to Endgate Adjustment .