Mode Valve Actuator Replacement W/D07

Notice: In order to avoid actuator damage, DO NOT apply power to the actuator when it is not installed in the HVAC module.

1. Remove the floor air outlet duct extension (1) from the floor duct (2).
2. Remove the center console. Refer to Console Replacement .
3. Remove the screws from the center console duct.
4. Remove the center console duct.



5. Disconnect the electrical connection from the mode actuator (10).



6. Remove the mode actuator mounting screws from the HVAC module.
7. Remove the mode actuator as an assembly with the actuator cam.

1. Install the mode actuator as an assembly with the actuator cam.

•	Line up the heater/defroster valve lever with the mode actuator cam slot.

•	Line up the A/C valve lever with the mode actuator cam.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the mode actuator mounting screws to the HVAC module.

Tighten
Tighten the screws to 1.6 N·m (14 lb in).




3. Connect the electrical connection at the mode actuator (10).



4. Install the center console duct.
5. Install the screws to the center console duct.

Tighten
Tighten the screws to 1.6 N·m (14 lb in).

6. Install the center console. Refer to Console Replacement .
7. Install the floor air outlet duct extension (1) to the floor air duct (2).

Mode Valve Actuator Replacement Without D07

Notice: In order to avoid actuator damage, DO NOT apply power to the actuator when it is not installed in the HVAC module.

1. Remove the floor air outlet duct extension (1) from the floor duct (2).
2. Remove the body control module. Refer to Body Control Module Replacement .



3. Disconnect the electrical connection at the mode actuator (10).



4. Remove the mode actuator mounting screws from the HVAC module.
5. Remove the mode actuator as an assembly with the actuator cam.

1. Install the mode actuator as an assembly with the actuator cam.

•	Line up the heater/defroster lever with the mode actuator cam slot.

•	Line up the A/C lever with the mode actuator cam.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the mode actuator mounting screws to the HVAC module.

Tighten
Tighten the screws to 1.6 N·m (14 lb in).




3. Connect the electrical connection at the mode actuator (10).



4. Install the body control module. Refer to Body Control Module Replacement .
5. Install the floor air outlet duct extension (1) to the floor air duct (2).