Schematic Reference: HVAC Schematics

Connector End View Reference: HVAC Connector End Views

DEFINITION: The blower motor operates with the HVAC controls in the OFF position.

Did you perform the Diagnostic System Check - Vehicle?

--

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

1. Turn the ignition ON, with the engine OFF.
2. Turn OFF the HVAC controls.

Is the blower motor OFF?

--

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

With a scan tool observe the Blower Motor PWM Speed parameter in the Heating and Air Conditioning data list.

Does the scan tool indicate that the Blower Motor PWM Speed parameter is near the specified value?

0%

Go to Step 4

Go to Step 6

4

1. With a scan tool, command the Blower Motor parameter ON in the Heating and Air Conditioning Scan Tool Output Controls.
2. Command the Blower Motor parameter OFF.

Does the blower motor turn OFF?

--

Go to Step 6

Go to Step 5

Inspect for poor connections at the harness connector of the blower motor control processor. Refer to Wiring Repairs and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 9

Go to Step 7

Inspect for poor connections at the harness connector of the HVAC control module. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 9

Go to Step 8

Replace the blower motor control processor. Refer to Blower Motor Control Processor Replacement .

Did you complete the replacement?

--

Go to Step 9

--

Replace the HVAC control module. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

--

Go to Step 9

--

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 2