Removal Procedure
- Remove the instrument panel accessory trim plate. Refer to
Instrument Panel Cluster Trim Plate Bezel Replacement.
- Remove the accessory switch from the instrument panel. Refer to
Accessory Switch Replacement.
- Remove the screws from the HVAC control module.
- Depress the control assembly retaining tabs and remove the HVAC control module from the instrument panel.
- Disconnect the electrical connectors from the HVAC control module.
Installation Procedure
Important: The key should be in the off position when connecting the electrical connectors to ensure proper calibration.
- Connect the electrical connectors to the HVAC control module.
- Install the HVAC control module into the instrument panel.
Notice: Refer to Fastener Notice in the Preface section.
- Install the screws to the HVAC control module.
Tighten
Tighten the screws to 1.9 N·m (17 lb in).
- Install the accessory switch to the instrument panel. Refer to
Accessory Switch Replacement.
- Install the instrument panel accessory trim plate. Refer to
Instrument Panel Cluster Trim Plate Bezel Replacement.
Important: Do not adjust any controls on the HVAC control module while the HVAC control module is calibrating. If interrupted improper HVAC performance will result.
- Start the vehicle and let run for one minute.
- Refer to
Control Module References for programming and setup information.