Removal Procedure
- Place the ignition switch in the OFF position.
- Disconnect the primary piston position sensor electrical connector.
- Remove the 2 primary piston position sensor screws (1).
- Remove the primary piston position sensor (2).
Tilt the rear of the position sensor downward and remove the sensor.
Installation Procedure
- Install the primary piston position sensor (2).
Notice: Refer to Fastener Notice in the Preface section.
- Install the 2 primary piston position sensor screws (1).
Tighten
Tighten the screws to 10 N·m (89 lb in).
- Connect the primary piston position sensor electrical connector.