GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2008 🢒 Yukon XL Denali 🢒 Preface 🢒 Cautions and Notices 🢒 Front Seat Cushion Outer Trim Panel Replacement

Front Seat Cushion Outer Trim Panel Replacement with HP2


Object Number: 1960368 Size: MF

Callout

Component Name

Preliminary Procedures

  1. Disconnect the lower portion of the seat back finish panel from the seat frame and lift upward to gain access to the screws.
  2. Remove the front seat lumbar actuator knob, if equipped. Refer to Driver Seat Lumbar Support Actuator Knob Replacement.
  3. Remove Recliner Handle If equipped. Refer to Driver or Passenger Seat Recliner Handle Replacement

1

Front Seat Cushion Outer Finish Panel Cover Screw (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
2 N·m (18 lb in)

2

Front Seat Cushion Outer Finish Panel Cover

Procedure

  1. Disengage the outer trim cover from the inner recliner cover.
  2. Pull outward to disengage the retainer clips.
  3. Pull finish panel in middle to remove from lumbar knob area.
  4. Slide front edge of finish panel forward to disengage from bracket.
  5. Disconnect the seat switch electrical connector.
  6. If replacing the cover, transfer necessary components.

Front Seat Cushion Outer Trim Panel Replacement Manual Seat without HP2


Object Number: 1678371 Size: MF

Callout

Component Name

1

Front Seat Recliner Lever

Procedure

Using a flat-bladed tool, push the retainer clip downward and pull outward to release the lever.

2

Front Seat Manual Lumbar Knob

Procedure

Using a flat-bladed tool, push the retainer clip downward and pull outward to release the knob.

3

Front Seat Adjuster Outer Finish Cover

Notice: Refer to Fastener Notice in the Preface section.

Procedure

  1. Remove the screw from front of the cover.
  2. Squeeze the tabs in the rear of the cover together to disengage the outer trim cover from the rear trim cover.
  3. Pull outward to release the retainers from the seat assembly.
  4. Disconnect the electrical connectors.

Tighten
2 N·m (18 lb in)

Front Seat Cushion Outer Trim Panel Replacement Power Seat without HP2


Object Number: 1678374 Size: MF

Callout

Component Name

1

Front Seat Adjuster Outer Finish Cover Screw

Notice: Refer to Fastener Notice in the Preface section.

Tighten
2 N·m (18 lb in)

2

Front Seat Adjuster Outer Finish Cover

Procedure

  1. Squeeze the tabs in the rear of the cover together to disengage the outer trim cover from the rear trim cover.
  2. Pull outward to release the retainers from the seat assembly.
  3. Disconnect the electrical connectors.
  4. If replacing the finish cover, remove the switches and install on new finish cover.