Removal Procedure
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Disconnect the electrical connector.
- Remove the wheel speed sensor retaining bolt.
- Release the wheel speed sensor wiring harness from the retainers.
- Remove the wheel speed sensor.
Installation Procedure
- Using a twisting motion, install the wheel speed sensor until fully seated.
Notice: Refer to Fastener Notice in the Preface section.
- Install the wheel speed sensor retaining bolt.
Tighten
Tighten the wheel speed sensor retaining bolt to 13 N·m (115 lb in).
- Connect the electrical connector.
- Install the wheel speed sensor wiring harness to the retainers.
- Lower the vehicle.
- Perform the
Diagnostic System Check - Vehicle.