Rear Axle Lubricant Replacement 10.5 Inch Axle
Removal Procedure
- Raise the vehicle. Refer to
Lifting and Jacking the Vehicle .
- Remove the rear axle fill plug.
- Remove the rear axle drain plug.
- Drain the lubricant into a suitable container.
- Inspect the drain plug for excessive metal particle accumulation. This accumulation is symptomatic of extreme wear.
- Clean the drain plug.
Installation Procedure
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the rear axle drain plug.
Tighten
Tighten the rear axle drain plug to 33 N·m (24 lb ft).
- Fill the rear axle. Use the proper fluid. Refer to
Approximate Fluid Capacities and
Fluid and Lubricant Recommendations .
- Install the rear axle fill plug.
Tighten
Tighten the rear axle fill plug to 33 N·m (24 lb ft).
- Lower the vehicle.
Rear Axle Lubricant Replacement 8.6 Inch Axle
Removal Procedure
- Raise the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Clean the area around the rear axle fill plug.
- Remove the rear axle fill plug.
- Remove the rear axle cover. Refer to
Rear Axle Housing Cover and Gasket Replacement.
- Drain the lubricant into a suitable container.
Installation Procedure
- Install the rear axle cover. Refer to
Rear Axle Housing Cover and Gasket Replacement.
- Fill the rear axle with axle lubricant. Use the proper fluid. Refer to
Approximate Fluid Capacities and
Adhesives, Fluids, Lubricants, and Sealers.
Notice: Refer to Fastener Notice in the Preface section.
- Install the rear axle fill plug.
Tighten
Tighten the rear axle fill plug to 33 N·m (24 lb ft).
- Lower the vehicle.