Short Duration Cold Start Lifter Tick Noise - keywords 5.3 6.0 cam engine L76 LC9 LFA LH6 LMG LS4 LY5 oil pressure start
| Subject: | Short Duration Cold Start Lifter Tick Noise |
| Models: | 2007-2008 Chevrolet Avalanche, Silverado, Suburban, Tahoe |
| 2007-2008 GMC, Sierra, Yukon |
| 2007-2008 Chevrolet Impala |
| 2007 Chevrolet Monte Carlo |
| Equipped with the 5.3 or 6.0 Active Fuel Management engines |
The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI.
Condition/Concern:
A customer may comment on a cold start engine tick noise. The noise explained may be an extended duration noise related to AFM (Active Fuel Management) valve lifters. The noise may repeat on subsequent cold starts. Noise will be camshaft speed and may last over 1 minute. Noise will only occur after a cold soak that is greater than four hours in duration.
Recommendation/Instructions:
Complete the current SI diagnostic for any symptom or DTCs found. If an extended duration lifter tick noise has been verified (usually greater than 1 minute), and the noise is considered excessive and repeatable, lifter replacement may be required. To repair this concern all lifters should be replaced with lifters obtained through GMSPO. There is no special part number necessary.
Note: The 6.0L engine, RPO code LFA has been built with updated lifters since 1-28-2008. 6.0 LFA engines built prior to 1-28-2008 may need the lifters replaced if the customer concern is as described in this PI.
Note: If a cold start lifter tick noise has been verified on any other 5.3L or 6.0L AFM engine, lifter replacement may be necessary. These engines (L76 LC9 LH6 LMG LS4 LY5) do not have a build date released for updated lifters.
Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed.
