Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
Schematic Reference: Selectable Ride Schematics | ||||
1 | Did you review the system and circuit description and perform the necessary inspections? | -- | Go to Symptoms | |
2 | Verify the fault is present. Does the system operate normally? | -- | Go to Testing for Electrical Intermittents in Wiring Systems | |
3 |
Does the test lamp illuminate? | -- | ||
4 | Connect a test lamp between the selectable ride switch output circuit and a good ground. Refer to Circuit Testing in Wiring Systems. Does the test lamp illuminate? | -- | ||
5 |
Does the test lamp illuminate in the ON position and off in the OFF position? | -- | ||
6 |
Does the test lamp illuminate? | -- | ||
7 |
Did you find the condition? | -- | ||
8 | Test the ignition positive voltage circuit for an open or a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | -- | |
9 | Repair the short to voltage in the selectable ride switch output circuit. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | -- | -- | |
10 | Repair the open in the selectable ride switch output circuit between the switch and Engine Wiring Harness Junction Block. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | -- | -- | |
11 | Repair the conditions as necessary. Refer to the appropriate procedure in Wiring Systems from the following list: Did you complete the repair? | -- | -- | |
12 | Replace the selectable ride switch. Refer to Electronic Suspension Switch Replacement . Did you complete the replacement? | -- | -- | |
13 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | |
