Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Instrument Cluster Schematics DEFINITION: This diagnostic applies only to the analog clock (Z75 only) located in the instrument panel upper console. | |||
1 | Did you review the operation and perform the necessary inspections? | Go to Step 2 | |
2 | Test the battery positive voltage circuit of the clock for an open, short to ground or a high resistance. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 6 | Go to Step 3 |
3 | Test the ground circuit of the clock for an open or a high resistance. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 6 | Go to Step 4 |
4 | Inspect for poor connections at the harness connector of the clock. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 6 | Go to Step 5 |
5 | Replace the clock. Refer to Clock Replacement . Did you complete the replacement? | Go to Step 6 | -- |
6 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |
