| Table 1: | Rollover Sensor Scan Tool Data Parameters |
| Table 2: | Supplemental Inflatable Restraint Scan Tool Output Controls |
Parameter | System State | Expected Value | Description |
|---|---|---|---|
Operating Conditions: Ignition ON | |||
Average Speed | -- | Varies | This displays km/h (mph). This is the average speed of the vehicle. |
Battery Voltage Signal | -- | Varies | This displays volts. This is the voltage input supplied to the rollover sensor. |
Current Power Mode | -- | Run | The scan tool displays Off, Accessory, Run or Crank Request. This is the state of the ignition switch. |
Engine Virtual Device | -- | Present | The scan tool displays Present or Not Present. |
Primary Key Status | -- | Valid | The scan tool displays Unknown, Valid or Invalid. This is the state of the primary key. |
Received Primary Key | -- | Varies | The scan tool displays the primary key received. |
ROS Occupant Containment Req. | -- | Enable | The scan tool displays Reserved, Disable or Enable. |
ROS Primary Key | -- | Varies | The scan tool displays the ROS primary key. |
SDM Occupant Containment Status | -- | Enabled | The scan tool displays Disabled or Enabled. |
Vehicle Speed Status | -- | Valid | The scan tool displays Valid or Invalid. This is the state of the vehicle speed. |
Output Control | Description |
|---|---|
Setup New ROS | This procedure should be used after a new rollover sensor has been installed. |
