J 42851 Front Cover Oil Seal Installer
Important: The engine front cover gasket is reusable.
Important: The engine front cover must be installed and the fasteners tightened while the sealant is still wet to the touch.
Important: The following method must be used when installing the engine front cover. Failure to follow the instructions will push the sealant out, which may cause an oil leak.
5.1. | Hold the front cover (1) up to the crankshaft (2). |
5.2. | Lift the front cover (1) while sliding the cover over the crankshaft (2). |
5.3. | Slide the front cover towards the engine block (5) while keeping the cover raised. |
5.4. | Lower the cover down over the dowel pin (4), allowing the front cover to rest on the sealant (3). |
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten
Tighten the battery cable channel bolt to 9 N·m (80 lb in).
Install the CMP sensor bolt.
Tighten
Tighten the CMP sensor bolt to 12 N·m (106 lb in).